EZ-Sealer Is Just That… Easy!

Professionally seal coat your own driveway in four (4) simple steps. Instructions for use:

1. Prep It
Start by cleaning the asphalt of your driveway; making sure to remove all sand, rocks, dirt and other materials. We’ve found it’s most effective to use a broom and sweep your driveway or to use a leaf blower.

If your driveway has cracks you will need to fill them with crack filler. Most any filler will do the job.

 

2. Mix It
Prepare your EZ-Sealer Residential Sealcoat Machine by doing the following:

  • Read the directions on the sealant container
  • Stir or agitate the sealant thoroughly until it is liquid and without any lumps
  • Ensure the strainer is in place in the EZ-Sealer tank
  • Pour the mixed sealant into the tank

 

3. Spread It
How to use your EZ-Sealer Residential Sealcoat Machine:

  • If your driveway is sloped or on a hill, place your sealcoat machine so it is always facing uphill; this helps contain the sealant so it will not run away from you when you open the valve.
  • Set your squeegee down and open the valve allowing the fluid to flow evenly.
  • Leave a 2-3 inch puddle of fluid down in front of the squeegee.
  • Move slowly up your driveway.
  • Close the valve four (4) feet before you reach the end of your driveway, letting the fluid diminish from the original puddle.
  • Lift the squeegee and return to where you started – Repeat!

4. Done


It’s Just that Easy!

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Buy Direct From Us or From One of Our Fine Dealers

Buy it on-line at Asphalt Sealcoating Direct.Com

Sealant for the EZ-Sealer Residential Sealcoating Machine can be found at these locations: local hardware stores